Pages

Saturday, October 15, 2016

Circa 2016

Are you doing this Temecula Quilt project that's been ongoing all year?  I neglected to print out the finishing instructions and now they are only available if you buy the whole quilt pattern.

I need to know the measurements of the first solid strip around the center, the size of the setting triangles etc.

Do you have the instructions you're willing to share with me???

I'm ready to work on it today!

4 comments:

  1. Sorry, Randy. I have not been doing it. I kind of overdosed on Temecula SALs a few years ago (doing 2, 3 or 4 versions of them), and haven't done one in years.

    ReplyDelete
  2. The instructions say : Add borders to center medallion - cut the following from dark print - 2 - 2" x 18 1/2" strips* 2 - 2" x 21 1/2" strips* * If your medllion ws slightly smaller or larger this is the step to get it back to the right size. Center Medallion should now measure 21 1/2".

    From setting fabric cut the following: 3 - 3 1/2" wof strips/ subcut 36 - 3 1/2" squares.
    1 - 3 1/2" wof strips/ subcut 8/ 3 1/2" squares/ cut once diagonally
    3 - 6" wof strips/ subcut 17 /6" squares/ cut twice diagonally
    5 - 1 1/2" x wof strips/ outer border
    Set 3 1/2" blocks using setting squares and triangles. Setting triangle are slightly over sized to allow for squaring up. You will need two units that are 5 x 3 blocks measuring 21 1/2" x 13 1/4" and two units that are 11 x 2 blocks once they are set with setting triangles, Use your 120 HST to make the outer border. You can adjust how many you use by adding or subtracting units needed. Hope this helps

    ReplyDelete
  3. Opps, I missed the final directions too. I think I can figure it out though. I have a few more 3 1/2" blocks to make.

    ReplyDelete